So, I just recently got into speedcubing. I have some cubes, and im leaning towards jigaloo to use on them. I already have some but I hear from some people it's terrible and melts your cube. WTF? Is it safe to use in moderation?
I use jigaloo, (i spray it in 2 directly opposite edges) it's good, just make sure to turn your cube a while after otherwise the layer might "glue", but don't worry, if that happens you just need to force the turn by wiggling the layer around a bit
If you put in too much (holding down button for 2 secs or more) the cube will turn rly slowly for a while. Also, not immediately turning the cube (all sides of it) after applying the lube might result in some glued pieces. (oh wait, I'm repeating myself lol)