GamerX102 wrote:What do you do when on the corners for the 1st face, the final corner is on the bottom when the 1st side is up?
I think that you are talking about the situation that is shown in the following image. In it, the same 3x3x3 is shown from two different views.
Here is how you can solve the corner. Place the green side on the top and do the following.
-Turn the yellow side counterclockwise.
-Turn the bottom layer clockwise.
-Turn the yellow side clockwise.
The corner's top color is on the side now. You can solve it like you normally would.
(You could also start by turning the orange side. See if you can figure it out.
If you were asking about something else, you can post a reply and say so.
I hope this helps.